A draft system does two things together: it keeps the beer in its intended condition and moves it into a glass. A problem in either job can show up as a poor pour.
Two paths meet inside the keg
- Gas supply
- The cylinder supplies CO₂ through a regulator, gas line and compatible keg connection.
- Inside the keg
- Gas above the beer applies pressure. The liquid outlet draws beer through the keg’s internal pickup arrangement.
- Beer delivery
- Beer travels through its connection, beverage tubing and faucet into the glass.
A ball-lock keg normally has separate gas and liquid posts and disconnects. A commercial keg uses a coupler matched to its valve family. Identify the actual hardware before connecting anything; similar appearance does not establish interchangeability.
Section references: Micro Matic — How do I tap a keg? · AHA — An Introduction to Kegging Homebrew.
The regulator sets pressure, not carbonation by itself
The primary regulator reduces cylinder pressure to a controlled downstream pressure. A high-pressure gauge and a downstream gauge have different jobs; neither directly measures dissolved CO₂ in the beer.
Holding pressure, liquid temperature and target carbonation must agree. A changed gauge reading is immediate compared with the time needed for the bulk beer to move toward a new equilibrium. Existing carbonation is therefore a condition to understand, not a number to infer from the gauge alone.
If several beers share one regulated manifold, they share that pressure setting. Beers needing different settings require independently regulated groups. A second gauge is not a second regulated output.
Section references: Micro Matic — Different CO₂ pressures.
Refrigeration is part of the dispensing system
The important temperature is the beer’s actual liquid temperature. A fridge display may describe air at a sensor somewhere else. Let conditions stabilise and check with a suitable thermometer.
A warm line or tower can cause gas to leave solution before beer reaches the glass. If the first pour after an idle period foams but the following pour improves, record that pattern; it is useful evidence about the beer path, not a complete diagnosis.
Plan cold storage and the dispensing route together. A keg that fits with its lid shut may still lack room for a coupler, disconnects or a gentle tube bend.
Section references: Micro Matic — Keep beer chilled.
The line controls the path to atmospheric pressure
At the open faucet, beer reaches the atmosphere. Along the way, elevation and resistance use the available pressure. Resistance depends on the tubing product and operating conditions; diameter alone does not provide a reliable universal value.
Three different questions
Carbonation asks which pressure matches the beer condition. Balancing asks how the dispensing path can work with that pressure. Line volume asks how much liquid fits inside the tubing. One answer cannot substitute for the others.
A faucet with a flow-control mechanism can add adjustable restriction, but it cannot correct a warm beer path, an incorrect fitting or uncertain cleaning.
Section references: Micro Matic — What is restriction?.
Verify the connections before testing the pour
Write down the gas and beer paths on your own equipment. Match every joint, including the cylinder valve, regulator inlet, thread type, tubing ID or OD, seals and required protection. Follow the exact hardware instructions for assembly and leak checks.
Prepare all beer-contact surfaces, record temperature and pressure, then observe a test pour in a clean glass. Record whether a problem occurs after idle time, throughout the pour or across every keg. Those distinctions are more useful than changing several settings at once.
Missing connector information remains a parts-selection gap. A completed sketch or calculator result does not confirm hardware compatibility.
Sources & scope
References and review
Component roles are explained from supplier and brewing-association sources. This is a functional explanation, not an assembly sequence or a product-specific pressure approval. No historical diagram has been reproduced.
- Micro Matic — How do I tap a keg?
- AHA — An Introduction to Kegging Homebrew
- Micro Matic — Different CO₂ pressures
- Micro Matic — Keep beer chilled
- Micro Matic — What is restriction?
Franklinbrew · Independently written reference · Version 1.0 · Reviewed 17 November 2026.