Draft systems & serving
Beer Line Volume Calculator
Know how much beer your line holds.
Enter the internal diameter and full length of one beer line. Find its filled capacity in millilitres, litres and US fluid ounces.
See the method & input checksYour line
Your result
Beer held in the line
Enter your line dimensions
— mL
Geometric capacity of a fully filled line.
Your dimensions, explained
- Actual internal diameter
- —
- Total hose length
- —
- Capacity per metre
- —
Only the hose is counted.
Keg dip tubes, couplers, shanks, faucets and other fittings add volume. They are not included in this result.
This is line capacity, not a prediction of beer discarded or cleaning fluid needed. Real use depends on your equipment and procedure.
Behind the calculation
Measure the bore.
Include the full length.
A geometric calculation with the assumptions made visible.
The equation
V = π × (ID / 2)² × L
- V
- Internal volume of the hose
- ID
- Actual internal diameter
- L
- Length measured along the hose
Units and an independent hand check
With ID in millimetres and length in metres, V in mL = π × ID² × L / 4. For a 4 mm bore and 2 m length, the radius is 0.2 cm and length is 200 cm: π × 0.2² × 200 = 8π cm³ ≈ 25.13 mL.
One inch is exactly 25.4 mm; one foot is exactly 0.3048 m. A US liquid gallon is 231 cubic inches and contains 128 US fluid ounces, so 1 US fl oz = 29.5735295625 mL. US fluid ounces are used throughout; imperial fluid ounces are different.
What this geometry assumes
The line has a constant, circular internal cross-section and is fully filled. Coiling the hose does not change its geometric capacity if the bore remains unchanged. Kinks, deformation, changes in diameter and trapped gas can make the actual liquid volume different.
For several sections with different bores, calculate each section separately and add their volumes. For several identical lines, multiply the single-line result by the number of lines. Accessories need separate measurements.
Zero, missing values and review prompts
Diameter must be positive; length can be zero. A blank field is not zero. Missing, negative or nonfinite inputs clear the previous result and show errors beside the fields. Extreme dimensions that cannot be represented reliably receive a numerical-range error.
Diameter below 1 mm, diameter above 25 mm, or length above 30 m triggers a review prompt. These are editorial checks for possible measurement or unit mistakes, not equipment limits or restrictions on the cylinder formula. The exact threshold itself does not trigger that prompt.
A tiny positive volume is shown as “< 0.01” in the selected output unit rather than rounded to zero. Very large values use scientific notation. A genuine zero-length result remains zero.
Why diameter accuracy matters
Volume grows with the square of the internal diameter. Doubling the diameter gives four times the volume; doubling the length gives twice the volume. Extra decimal places in the result do not improve the accuracy of a nominal or uncertain diameter.
Sources & review
Wolfram MathWorld · Cylinder, equation 5
Geometry: volume = πr²h.
NIST Handbook 133 (2025), Appendix E
Length and US liquid-volume definitions used for conversions.
Reviewed 17 November 2026 · Version 1.0
Formula, units and software checks; no physical hose calibration.